Daily Archives: July 12, 2014
One of the staples of fastpitch softball tournaments is the international tie breaker, or ITB. If you’re not familiar with it, it’s a way of trying to get to a winner faster in a tie game. After seven innings, or the time limit expires if you’re playing with one of those, each team starts the inning with a runner on second base. The runner on second is the last out from the previous inning. Each team gets three outs to try to score as many runs as they can in their half-inning. If one score more than the other, they win. It’s sort of like the soccer shoot-out for those of you watching the World Cup, or a shoot-out in hockey. While I said “as many runs as you can,” in most instances you’re trying to get one run. Most games that go to the ITB are not double-digit slugfests. They’re usually low-scoring affairs, which is why you start with a runner on second. Softball strategy 101 says the team at bat should sacrifice bunt the runner to third, and then take two outs to try to bring her home. That’s what most teams do. But I have a strategy that, if you have the right pieces in place, can help you get that runner at least to third with no outs. It depends on two things. The first is a runner with decent speed – enough to make it a challenge for the shortstop to cover on a steal. The second is a hitter with the ability to slug bunt, i.e., show bunt then pull back and slap the ball hard on the ground. Here’s how you take advantage of them. If you can get the hitter to a favorable count such as 2-0 where the pitcher really needs to throw a strike, have your runner on second steal third, and your hitter execute a slug bunt. When you do this, you’re starting out by giving the defensive team what they expect – a bunt. Third base will likely be playing up for the bunt, which means the shortstop must cover third on a steal. When your runner takes off, the shortstop will likely start moving to cover third on the throw from the catcher. You may also get the second baseman moving to cover first if the first baseman is also playing close. That opens up some space. After showing bunt and pulling back, the hitter attempts to slap the ball on the ground, either to where the shortstop or second baseman normally plays. There are several possible good outcomes. One is if the shortstop or second baseman did start moving to their respective corners and the hitter gets the ball on the ground, it will roll through the area they vacated, perhaps to the outfield grass. Since your runner was already stealing, she may be far enough along to keep going and score. And you have a runner on first with no outs. What about if the hitter swings and misses? No problem. Perhaps the act of pulling back gets the shortstop to freeze long enough to allow your runner to get to third unchallenged. Even if she keeps going it’s still a tough play at third. A poor throw or a miss and your runner is either safe at third or headed home. Again, you also have a runner at first with no outs. And that runner will likely be standing on second after the next pitch, because the defense can’t afford to let the runner on third score. If the hitter goes for the slug and hits it directly to a fielder, the runner on second is still likely to get to third cleanly, although the batter may be out depending on her speed. In that case you’re no worse off than if you’d sacrifice bunted. Any of those outcomes will make you look like an offensive genius. About the only thing that can go wrong is if your hitter pops up instead of putting the ball on the ground. In that case the batter is out and the runner who was on second will probably get doubled off. Then everyone thinks you’re an idiot. Still, the odds are in your favor. With the summer tournament season heating up, you’re likely to face an ITB sooner or later. Keep this strategy in mind and you just may improve your odds of winning. Now it’s your turn? What other non-standard strategies do you employ on the ITB?